Peugeot 2008 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
275 Posts
Discussion Starter #1 (Edited)
I've searched and can't find an on-line resource for this specific to the 2008 or 208 (which I'm guessing is the same)

4 screws (2 x normal 2 x torx) and it won't budge.

Anyone have any ideas?

Oops! Just noticed this is under 'technical and really should be in 'main message' section :(
 

·
Registered
Joined
·
23 Posts
Take the side trim off where the door closes, remove the screws and pull gently from the top first, it’s also on clips as well as the screws.
 

·
Registered
Joined
·
275 Posts
Discussion Starter #3
OK will get my car plastic pry tool set out tomz and see about removing the side panel...that's perhaps where I came unstuck before.

Thank you!!
 
1 - 3 of 3 Posts
Top